Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE area around the electrolyte level electrolyte level is between the dry cloth, static electricity may below the midway point between the (e.g. commercially available LEVEL (U.L.) line. with baking soda (sodium a large amount of water or or there is no display of the UPPER so surface tension causes electrolyte surface to bulge and poles appear bent. (B) Low: Electrolyte level is not up to bottom of sleeve, so poles appear straight and not bent. REMARK If water is added to above the bottom tip of the sleeve, use a pipette to remove electrolyte.

Neutralize the removed electrolyte with sodium bicarbonate, then flush it away with a large amount of water. If necessary, contact your Komatsu distributor or your battery maker. 4 - 50 1. Use a wet cloth to clean the ar lines and check that the ele UPPER LEVEL (U.L.) and LO If the battery is wiped with a cause a fire or explosion. 2. If the electrolyte level is below UPPER LEVEL (U.L.) and LOW cap (2) and add purified wate replenishment water for a batte 3.

After adding distilled water, tig REMARK If distilled water is added to above use a syringe to lower the level to Neutralize the removed fluid bicarbonate), then flush it away w consult your Komatsu distributor o When it is Impossible to Check Electrolyte Level from Side of Battery If it is impossible to check the ele battery LEVEL line on the side of the batte 1. Remove cap (2) at the top of the filler port (3), and check th electrolyte does not reach the (e.g. commercially available re so that the level reaches the LEVEL line) without fail. (A) Suitable level: Electrolyt 2.

After adding distilled water, tig When it is Possible to Use Indicato If it is possible to use an indicator t o check the electrolyte level, follow the i nstructio