Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE it. 4 - 68 Do not fill the new filter ca Remove cap (B) and insta 6. When installing, tighte n until the packing surface c ontacts th e seal surface o f the filte r holder, the n tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packi ng will be d amaged and th is will lea d to leakag e of fuel. I f the filter cartridge is too lo ose, fuel will also leak from the packi ng, so always ti ghten the correct am 7. Turn the valve (1) at t he bottom of the fuel tank to the OPE N position 8. After completing the r eplacement of filter cartridg e (2), blee Bleed the air as follows: 9.

Add fuel to the fuel ta nk until full (to FULL mark o n the fuel 10. Insert the key in the st arting switch and turn the k ey to the O position (B). The electric priming pump is actuated. position (B). The electric priming p 11. Hold the key at the ON position (B) for 30 seconds , then retu it to OFF position (A) and wait for 10 seconds. 12. Repeat Steps 10 and 13. After replacing the filt er cartridge, start the engine and run it at low idling fo r 10 minu Check for leakage of o il from the filter seal surface.

If any oil i s leaking, check the tight ening of the filter cartridge If there is still oil leak age, repeat Steps 1 - 4 to r emove th e filter cartridge , and if a ny damage or embedded foreign material in the packing surface is found, re place it wit h a new cartrid ge and re peat Steps 5 - 13 to i nstal