Komatsu — 12.12 ADJUSTMENT OF WORK EQUIPMENT

ADJUSTING BRACE LL WARNING If maintenance is carried out with the engine running, always have one worker sitting in the operator’s seat while another worker carries out the maintenance. Both workers must mutually confirm the safety during the operation. Start the engine and use inching control to tilt to the left and right. Adjustment can be carried out easily by rotating the brace handle while raising and lowering. l When extending the brace Set the blade at FLOAT and rotate the brace handle to adjust. REMARK When operated in this way, the blade is tilted, so the handle gradually becomes heavier.

When this happens, return the blade from the tilt position to the horizontal position and turn the handle again according to the procedure given above. (3.9 - 5.9 in) (84.6 in) AE105592 SHIM ADJUSTMENT Adjust the thickness of shim so that the in the axial direction (shown by the arrow) (0.04 in). ball joint play (7 points) does not exceed 1 mm I I play. Measure clearance “A” and remove bolts 0. Install shim @ having its thickness of “A” mm to “A + 1” mm (“A” in. to “A + 0.04” in) in place with bolts 0. Confirm that ball joint can move smoothly after tightening bolts. Remove shim @ and tighten bolts @ to eliminate the ball joint 2-67