16. TROUBLESHOOTING 16.4.2 CHASSIS Main causes Remedy Problem Check, repair) Oil pressure in torque converter fails to rise Improper tightening of oil pipe, pipe joint, air leaking in or oil leaking out because of damage Wear, scuffing of gear pump Insufficient oil in transmission case Check, replace) Add oil to the specified level. For details, see CHECK BEFORE STARTING Clean.
For details, see EVERY 1000 HOURS SERVICE Clogged oil filter element strainer in transmission case Torque converter is overheats l Clogged radiator (0 Clean or replace) l Clogged oil cooler l Oil pressure too low (0 Clean or replace) l Go to “Oil pressure in torque converter fails to rise” l Lack of flow of lubricant caused by wear of power train gear pump (e Replace gear pump) (o Replace fan pump motor) l Lack of flow of lubricant caused by wear of fan pump motor Torque converter oil temperature l Defective oil temperature gauge l Defective contact in wiring connection (o Replace oil temperature gauge) (o Check, repair) Lacks drawbar pull (machine does not pick up speed) gauge does not work l Lack of engine horsepower l See Engine related parts l Oil pressure in torque converter is too low l Go to “Oil pressure in torque con- verter fails to rise” (o Check, repair) l Steering clutch is slipping Machine doesn’t start by engaging the gear shift lever l Lack of oil in steering clutch case l Add oil to the specified level.
For details, see CHECK BEFORE STARTING l Transmission oil pressure does not rise l Go to “Oil pressure in torque con- verter fails to rise” (L’ Check, replace) o Clean.
For details, see EVERY 1000 HOURS SERVICE l Steering clutch slips 0 Wear, scuffing of gear pump o Clogged oil strainer element in steering clutch case (o Adjust linkage) (o Check brake pressure) When steering lever on one side is pulled, machine continues to travel straight forward instead of turning l Brake is not applied on side which is pulled pedal are depressed Machine doesn’t stop when brake l Defective brake adjustment (o Adjust linkage) (o Check brake pressure) Track comes off l Track is too loose l Adjust track tension. For details, see WHEN REQUIRED. Sprocket develops abnormal wear l Track is too loose or too tight l Adjust track tension. For details, see WHEN REQUIRED.
Brake rises too slowly or does not l Lack of hydraulic oil l Add oil to specified level. For rise at all (or blade tilts too slowly) details, see EVERY 250 HOURS SERVICE Ripper moves too slowly l Lack of hydraulic oil l Add oil to specified level. For details, see EVERY 250 HOURS SERVICE (o Tighten) l Leakage from piping Insufficient force of ripper 2-90