16. TROUBLESHOOTING 16.4.4 APS (Automatic Priming System) Problem Main causes Remedy Engine does not start at all. l Nozzle clogging (dust, paraffin precipitation, defective nozzle) l Defective glow plug (e Clean, change to specified fuel, replace nozzle) (0 Replace) (o Check, repair) l Fuel pipe collapse, fuel leak, clogging l Defective wiring l Fuse breaking (o Check, repair) (e Replace) (0 Replace) l Defective APS controller Engine does start smoothly but much white smoke emits Nozzle clogging (dust, paraffin precipitation, defective nozzle) Defective glow plug (0 Clean, change to specified fuel, replace nozzle) Replace) Replace) Check, repair or replace) or the engine stop.
Fuse breaking Alternator functional defect (Alternator output shortage) Defective APS water temperature sensor Defective APS controller (0 (0 (* (0 (0 Replace temperature sensor) When loaded, the engine will emit black smoke and stop. l Defective APS water temperature (0 Replace temperature sensor) Replace) l Deposited heater relay contact point sensor (o Replace heater relay) Burner is ignited and preheating monitor lamp remaining lighted.
Preheating monitor lamp does not become bright (when the temperature of the engine l Disconnection in electrical intake air heater and glow plug (o Replace) l Defective wiring (o Check, repair) cooling water exceeds 2O”C, the engine preheating system is in normal condition) l Defective timer (e Replace) l Glow plug is not heated red. l See item “Preheating monitor lamp does not become bright” Burner is not ignited l Fuel is not or less sprayed. o Nozzle clogging (dust, paraffin, (o Clean, change to specified fuel, replace nozzle) precipitation, defective nozzle) o Defective APS controller (0 Replace) 2-92