l When loosening tension It is extremely dangerous to release the grease by any method except the procedure given below. If the track tension is not relieved by this procedure, please contact your Komatsu dis- 1. Loosen plug @ gradually to release the grease. 2. Turn plug @ a maximum of one turn. 3. If the grease does not come out smoothly, move the machine backwards and forwards a short distance. 4. Tighten plug 0. 250 5. To check that the correct tension has been achieved, move the machine backwards and forwards. 6. Check the track tension again, and if the tension is not correct, adjust it again.
24.2.4 CHECK AND TIGHTEN TRACK SHOE BOLTS If the machine is used with track shoe bolts @ loose, they will break, so tighten any loose bolts immediately. l 1. Method for tightening (shoe bolt) First tighten to a tightening torque of 686 + 69 Nm (70 f 7 kgm, 506 i: 51 Ibft)) then check that the nut and shoe are in close contact with the link contact surface. 2. After checking, tighten a further 120” + 10”. a 1. Method for tightening (master link connecting bolt) First tighten to a tightening torque of 490 & 49 Nm (50 f 5 kgm, 362 ? 36 Ibft) then check that the link contact surfaces are in close contact. 2. After checking, tighten a further 180” _’ IO”.
Order for tightening Tighten the bolts in the order shown in the diagram on the right. I AD053090 3-29