Komatsu — 24.2 WHEN REQUIRED

When the nut is rusted and is removed by gas cutting, cut on both sides of the nut as shown in the diagram. Be careful not to damage seat surface. If it is damaged, repair it. Be careful not to get spatter on the mounting surface. Cut on both side l Method of using power wrench The power wrench set is equipped with a special socket. This socket is designed so that it grips the nut and prevents the wrench set from coming pull out. This means that the tightening operation can be carried out by one worker. This socket has a double construction, and is designed so that the outside can rotate 30”. It is used as follows.

Align the hexagons of the inside socket and outside socket, then insert the nut that is to be tightened or loosened. Rotates 30” After inserting the nut, turn the. outside socket 30” clockwise. When this is done, the outside socket will catch the notch in the nut seat surface, and the wrench will not come off. Put the reaction arm in contact with the blade rib, and tighten or loosen. AE106030 Turn the outside socket counterclockwise, and remove the wrench. 3-32