Komatsu — 24.5 EVERY 500 HOURS SERVICE

24. SERVICE PROCEDURE 24.5.2 REPLACE TRANSMISSION FILTER ELEMENT TRANSMISSION LUBRICATING FILTER ELEMENT AND TORQUE CONVERTER OIL FILTER ELEMENT ih WARNING Before opening the filter case, depress the brake pedal several times to release the pressure, then lock the brake pedal. If there is still pressure inside the filter, the oil may spurt out. 1. Remove the inspection cover on right fender. 2. Remove bolt 0, pull up cover @J, then remove the element @ and valve together with cover 0. 3. Remove the bolts tightening the valve, take out element 0, wash the removed parts and the inside of the case, then install a new element. Replace the O-ring at the same time.

AL116560 24.5.3 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL 7 g WARNING-1 There is danger that the oil may spurt out under internal pressure, so to the side, and gradually turn the plug to release the internal pressure before removing the plug completely. 1. Place the machine on a horizontal place. 2. Remove oil level plug @ and check whether the final drive case is filled with oil to lower edge of the plug hole. 3. If the oil level is still too low, add gear oil through oil filter plug $$ until the oil overflows. Before removing oil plug 0, remove all the mud and dirt from around oil filler plug 0. Be careful not to let any dirt or sand get in when adding oil.

For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 3-53