Komatsu — 28.1 PROCEDURE FOR SELECTING RIPPER POINT

28.

PROCEDURE FOR SELECTING RIPPER POINT 28.1 PROCEDURE FOR SELECTING RIPPER POINT Procedure @ Install standard point @ T Procedure @ No (less than 70%) Install standard point @ Excessive generation Check wear No (Whole point of heat at point (Only tip of point is worn) is worn evenly) Yes Procedure @ Check for cracks or breakage Yes I No No I I c J Soft - Hard Soft - Hard Soft t--t Hard Soft +--r Hard + c Shale, lime stone Basalt, andesite, granite, chest All type of general rock Sand stone Typical rock l Little quartz, little wear 0 Proportion of quartz is extremely high (70% - 95%), point wears rapidly l Proportion of quartz is not so high (40 - 70%) Features l Deposited in layers, so rippin{ is easy l Rock is not in layers or seams, so heat is generated at point, point wear rapidly, ripping is difficult 8 Point for lime stone 0 Symmetrical shape @ Standard point 0 @ 0 b Symmetrical shape b Yellow b Short ~Turn and use again l Non-symmetrica shape l Non-symmetrical l Symmetrical shape shape l Yellow l Yellow l Red l Red Suitable point l Short l Long l Long l Short AL116850 AL116840 -T!!

Shape ~ / Part No. 17M-78-21350 195-78-21331 195-78-29130 195-78-29140 1 195-78-21333 AL116840 AL116840 AL116850 5-4