Komatsu — 11.1 MONITOR PANEL

11. EXPLANATION OF COMPONENTS 2. POWER TRAIN OIL TEMPERATURE GAUGE This gauge indicates the oil temperature of the torque converter outlet. If the temperature is normal during operation, the green range will light. If the red range lights up during operation, move the fuel control lever to lower the engine speed to approx. 3/4 of the full speed, reduce the load and run until the oil temperature enters the green range. If the power train oil temperature enters the red range, and the power train oil temperature monitor flashes and the alarm buzzer sounds, stop the machine and run at low idling until the oil temperature enters the green range.

Red Yl n El H H Green1I(H C NOTICE If the power train oil temperature gauge often enters the red range, we recommend you to lower the travel speed one range (for example, F2 + Fl) to reduce the load on the power train when operating. 3. FUEL GAUGE This gauge indicates the amount of fuel in the fuel tank. If there is enough fuel in the tank while the engine is running, the green range lights. If the red range lights, there is less than 130 e (34.32 US gal, 28.6 UK gal) of fuel in the tank. When the red range lights, add fuel. Green -iI H El -E Ma F B Red A REMARK The display is not directly proportional with the remaining amount of fuel. A0104450 4.

SERVICE METER This meter shows the total operation hours of the machine. The service meter advances while the engine is running - even if the machine is not traveling. Set the periodic maintenance intervals using this display. When the engine is running, the green pilot lamp at the top of the meters flashes to indicate that the meter is advancing. Meter will advance by 1 for each hour of operation regardless of the engine speed. El m 5. PREHEATING MONITOR This lamp indicates the engine preheating time when starting the engine by operating APS (Automatic Priming System) in the cold weather. When the preheating switch is placed in ON, this lamp lights and goes out after approx.

80 seconds, indicating that the preheating of the engine has been completed. AD104470 2-l 1