CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the engine side cover on the right side of the chassis. 2. Remove dipstick @$I and wipe the oil off with a cloth. 3. Insert dipstick @fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick 0. If the oil level is below the L mark, add engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. AL116000 5. If the oil is above the H mark, remove drain plug 0, loosen drain valve @ to drain the excess oil, then check the oil level again. 6.
If the oil level is correct, tighten the oil filler cap securely and close the engine side cover. REMARK l Check the oil level with the engine stopped. l When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. l If the machine is at an angle, make it horizontal before checking. l When adding oil, remove the dipstick from the holder to release the air inside the crankcase. 2-40