Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION FASTENING AND REMOVING SEAT BELT WARNING 3 - 80 Always install a sea t belt on machines equipped w Before fitting the s eat belt, check that there is no pro blem in the mounting b racket and mo unting belt o f the belt. If the belt is worn or damaged, replace it. Replace the seat be lt every three years, even if their ou tside is free from problem. The year o f manufacture is woven on the back side of the belt. seat belt before starting operations. t belt during operations. t or right side of the seat belt when fastening it. Always fasten the seat belt before starting operation Always use the sea t belt during operations.

Do not twist the lef t or right side of the seat belt whe Check that the bolts of the mount installing the sea t belt to the machine are not loose . If they are l oose, tighten t hem. The tightening torq ue for the mounting bolt is 24.5 ± 4.9 Nm (2.5 ± 0.5 kgm, 18.1 ± 3.6 lbft). at belt unit. If the belt surface is scratched or frayed or if the fi ttings are broke n or deformed, re place the se at belt u FASTENING AND REM OVING SEAT BELT depress the brake pedal fully, and adjust the seat so that your back is pressed against the the seat position, adjust tether belt (1).

Tense nd install it when there is no one sitting on the t and hold tongue (4) connected to wind-in and pull out the belt slowly so that the belt will omen sufficiently. ) in buckle (3) until it clicks. The belt is pulled -in mechanism (2) until it is fitted to your belt is locked under this condition and cannot nymore. Fit the belt to your abdomen without 1. Sit on the seat, backrest. 2. After adjusting the tether belt a seat. 3. Sit on the sea mechanism (2) cover your abd 4. Insert tongue (4 back into wind abdomen. The be extended a twisting it.

nd install it when there is no o ne sitting on the t and hold tongue (4) connected to wind-in and pull out the belt slowly so that the belt will omen sufficiently. ) in buckle (3) until it clicks. The belt is pulled 4. Insert tongue (4 -in mechanism (2) until it is belt is locked under this condi fitted to your tion and cannot REMARK If the belt is locked before the tongue is inserted in the buckle, let it retur n to the wind -in mechani sm, then repe at the above procedure fr om the start. 5. Pull the belt to check that it is securely locked 6. When removing the belt, press the red button The belt will aut