. OPERATION TROUBLESHOOTING 3 - 126 REMOVE AND INSTALL BA TTERY ion cover (1). s) and (B) of the battery mount , disconnect the ground terminal rminal) first. 1. Open hydraulic tank inspect 2. Remove nuts (A) (2 place holder. 3. When removing the battery (normally the negative (-) te It is extremely dangerous if the positive (+) terminal a sparks. Loosen the terminal nut a battery. 4. When replacing the battery, with the battery mount hold Tightening torque:(A) 3.92 - lbft)} (B)9.8 - 1 5. When installing the battery, Insert the hole of the termina Tightening torque: 5.9 to 9.8 (0.6 to 1. 1. Open hydraulic tank inspect any tool forms a contact between nd the chassis.
This will cause nd remove the wiring from the 4. When replacing the battery, fit the battery securely in position er. 5.88Nm {0.4 - 0.6 kgm (2.9 - 4.3 9.6 {1.0 - 2.0 kgm (7.2 - 14.5 lbft)} connect the ground cable last. l on the battery and tighten the nut. Nm 0 kgm, 4.3 to 7.2 lbft) PRECAUTIONS FOR BATTE RY CHARGING erly, it may explode. Accordingly, TERY IS DISCHARGED (PAGE ual attached to the charger, and arger to match the voltage of the voltage setting is mistaken, it will n the charger, and this will cause arger clip of the charger to the tery, then connect the negative (-) o the negative (-) terminal of the clips securely.
I f t he battery is charged improp charge it according to "IF BAT 3-125)" and the instruction man ual attached to the charger, and arger to match the voltage of the voltage setting is mistaken, it will observe the following items. Adjust the voltage of the ch battery to be charged. If the lead to overheating and fire o n the charger, and this will cause arger clip of the charger to the an explosion. Connect the positive (+) ch positive (+) terminal of the bat tery, then connect the negative (-) charger clip of the charger t battery.
Be sure to attach the Set the charging current to 1/ 10 of the value of the rated battery capacity; when carrying out rapid charging, set it to less than the rated batter y capacity. If the charger current is too hig h, the electrolyte will leak or dry up , and this may cause the b attery to catch fire and explode. If the battery electrolyte is fro zen, do not charge the battery or start the engine with a different power source. ll ignite the battery electrolyte and cause the battery to explode. There is a danger that this wi ll ignite the battery electrolyte and cause the battery to expl Do not use or charge the batt ery if the battery electrolyte level is below the LOWER LEVE L line.
This may cause an explosion. Check the batte ry electrolyte level periodically an d add distilled water to bri ng the electrolyte leve to the UPPER LEVEL line.