. MAINTENANCE SERVICE PROCEDURE 2. Remove 3 clips (1), then remove dust cup (2). 3. Remove outer element (4). flashes immediately, replace the inner and outer 4 - 23 CLEANING OR REPLACING OUT 1. Open engine side cover on t NOTI CE Neve r remove inner element (3). If it is removed, dust will enter and cause engin e trouble. NOTI When cleaning the dust cup, do not r 4. C lea n the inside of the air cle NOTI CE nner element must not be used again even after cleaning. When The i nner When replacing the outer element, replace the inner element at the same t ime. 5.
D irec t dry compressed air (le ss than 0.69 MPa (7 kg/cm2 , 99.4 PSI)) direc 1) R ti s 2) A e SI)) to the outer element (4 ) from inside along its folds, then irec t it from outside along it s folds and again from insid 1) R eplace any outer elem ent which has been cleaned 6 mes or used for 1 year. Replace the inner element at the ame time. fter cleaning, if the air lements.