Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE ADJUST PLAY IN CENTER BALL WARNING Adjust as follows. 4 - 45 When adjusting, always set the work equipment lock lever to t he LOCK p osition except when operati ng the blad It is necessary to adjust t he shim at the center ball porti on in the following cas When there is play in When the blade is rea ssembled after having been re moved fo r transportati on of the m If the adjustment is not m ade, the play will become large r. Sand an d soil will ent er the ball p ortion and t his will c ause premature wear and dam Adjust with shims so that the play at the center ball is 0. 2 - 1.2 mm (0.008 - 0.047 in). loosen bolt (2). 1. Remove bolt (1) and 2.

Remove all shims (3) so that dimension circumference. 3. Measure clearance (A of (A) + (0.2 -1.2 mm 4. Select a shim thickne several shims), the temporarily tighten b 5. Angle and tilt the bla If the blade moves sound, the adjust If there is a squea smoothly, add shi If the play at the b 6. If the work equipmen (2). Tightening torque: 336.3-419.5lbft) 1. Remove bolt (1) and 2. Remove all shims (3) and temporarily tighten bolts (1) and (2 so that dimension (A) is uniform around the whole ) and decide a shim thickness of a range circumference. Measure clearance (A of (A) + (0.2 -1.2 mm (0.008 - 0.047 in)). 4.

Select a shim thickne ss that will give the set thicknes s (remove several shims), the n return to the original position and olts (1) and (2). de. temporarily tighten b 5. Angle and tilt the bla If the blade moves smoothly without making any squeaking ment is complete. king sound or the blade does not move ms. If the play at the b all is still excessive, remove m ore shims 6. If the work equipmen (2). Tightening torque: 336.3-419.5lbft) t moves smoothly, tighten bolts (1) and 456 - 569Nm (46.5 - 58kgm Standard shim thickness Shim thickness: 1.0 mm (0.04 in) (x 2), 2.0 mm (0.08 in