. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 55 2. Remove clamp (6), ins ert a bar between alternator (7 ) and th cylinder block, and use it to hold alternat or (7) i n position. To prevent damage to alternator (7) when holdin g it in position insert a wooden block between the bar a nd alternato r (7). 3. Loosen bolts (8) and ( 4. Use t he bar to move al ternator (7) and ad just th e bel t tension 5. Tighten bolts (8) and ( 9) to hold alternato 7. Instal 8. Instal REMARK Check each pulley for b reakage and wear of the V-groove. In p articular, check that the V-b elt does not touch the bottom of the V-groove .
nd, please contact your Komatsu distributor for replacement of the pulley. and there is no allowance for adjustment, or if it is cut or cracked, please contact your replacement. If any abnormality is fou nd, please contac t your Komatsu distributo r for replacement of th If the bel t is stretched and there is no wanc Komatsu distributor for When adjusting the V-b elt, do not press th e alternato r directly with a bar, but put a wood piece, etc. in-between them. If the V -belt has been re placed with a new part, t here will be initial el ongation, so inspect a nd adjust it again after one-hour of operation.