. MAINTENANCE SERVICE PROCEDURE in and out until it becomes heavy. REMARK remove the plug at the top of the fuel out of fuel, use the same procedure to CHECK ELECTRIC WIRING AROUND STARTING MOTOR, ALTERNATOR CAUTION side 2. Remove 6 mounting bolts from engine side cover (2) on the right side of the machine, then remove the engine side cover. are any loose terminals. 4 - 64 14. After replacing filter cartridge (5), bleed the air fro m the fu 15. Fill the fuel tank with fuel (to the position where t he float is 16. Loosen the knob of pre-filter and fuel mai After the engine runs operate feed pump (6 17. After finishing the air bleeding, push in the knob of feed pu (6) and tighten it. 18.
After replacing the fi lter cartridge, start the engin e and run it for 10 minutes at low idlin Check that there is n any leakage of fuel is 1 - 7 to remove the fi is found, replace the o leakage of fuel from the fil ter seal s urface and the transparent c found, check that the filter ca rtridge is tightened properly. If the fue lter cartridge, then check the packing s urface for damage or embe cartridge with a new part, th en repea t Steps 8 - 17 to install the n f there are signs of a short circuit in the electrical wiring, as k your Ko matsu distributor immediately to carry out repairs. 1.
Remove 4 mounting bolts of cover (1) under the engine s cover on the left side of the machine, then remov e cover ( 3. Check if there are s igns of a short circuit in the electrical wiring and check if there a Tighten any loose te rminals. In particular, check the wiring of the starting motor and al