. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING REMARK Check the O-rings in the plugs for damage. If 4 - 72 The oil is at high temperature im mediately after the machine has been operated. Wait for the oil to co ol down before s tarting the opera If there is still pressure remaining inside the case, the oil or p lug may f Loosen t he plug slowly to releas Refill ca pacity: each 3.5 liters Prepare a container to catch Prepare 1. Set the TOP mark at the to p, with the UP mark and plug (P) surface. P) to catch the oil. ith the handle and drain the oil. P) perpendicular to the ground 2. Set a c ontainer under plug ( 3.
Remov e plugs (P) and (F) w ith the handle and drain the oil Check the with new o or damage. If necessary , replace 4. Tighte n plug (P). lug (F). 5. Add oil through the hole of p 6. When oil begins to overflow from the plug (F) hole , install plug (F). ning torque of plugs (P) and (F): 9.8 Nm (7 ± 1 kgm, 50.6 ± 7.2 lbft) Tighte ning torque of plugs ( 68.6 ± 9.8 Nm (7 ± 1 kgm, 5 CHECK CLAMP TIGHTENING PORTIONS FOR MACHINE INTAKE/EXHAUST PIPI NG Please ask your Komatsu distrib utor to check the tightening of the clamps between the air c leaner - turbocharger - aftercool er - engine.