. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE pressure of the accumulator has gone down. Please contact your Komatsu 4 - 79 3. Raise the w ork equipment ( blade) to t he maximum height. NOTICE owing procedure for lowering the blade to the ground within 15 seconds after stopping the engine. Carry out the foll owing procedure f or lowering the blade to th e groun d within 15 second When the engine is stopped, the pre ssure inside the accumula tor gradually goes down, s o this inspection can be carried out only immediately after the engine is sto pped. 4.
Leave the work equipment r aised to th e maximum height, t urn the starting switch to the O FF position and stop th e engine 5. 6. Turn the ke Turn the w y in the starting ork equipment lo switch to t ck lever to he ON FREE positi positi 7. Operate the blade control le ver fully in t he direction t o lower the blade. REMARK Check that the area around the machine i s safe, then operate the blade control le ver to the LOW ER position . 8. Check that the work equipm ent goes d own to the gr ound under its own wei ght. etes the inspection. 9.
This compl etes the inspecti NOTICE If operations are continued when th e function o f the accumul ator has dropped, it becom es impossible to release the re maining pressure in the h ydraulic circuit wh en there is a failure in the machine . I distributor. Work equip ment does not g Stops while