. OPERATION EXPLANATION OF COMPONENTS E.C.S.S. (ELECTRONIC CONTROLLED SUSPENSION SYSTEM) SWITCH (If equipped) WARNING will move. and the E.C.S.S. is 3 - 51 If the mac hine is traveling or the work equipme nt is raised, the moment the E .C.S.S . switch is turned ON, the w ork equip If operatio ns are carried out with the E.C.S.S. s witch at the ON position, the momen t the E.C.S .S. switch i s operated, the t may move. Never tur n the E.C.S.S. switch ON during insp ection or maintenance. The work e quipment will move a nd th is will crea s situation. NOTICE op the machine and lower the work equipment to the ground before operating the E.C.S.S. switch.
Always st op the machine and lower the work e quipment to the ground befor e operating the E .C.S.S. When carr ying out inspection and maintenance , first lower the work equipmen t to th e ground, th en tur n the E.C.S .S.switch before sta rting the inspection and maintenanc e operation. S.S. switch OFF. When car rying out leveling work, turn the E.C. The E.C.S. S. is a device that uses the hydrau lic spring effect of an accumulato r to absor b the v ibration of the cha during trav el, allowing the machine to travel This switch (12) is used to turn the E.C.S.S. Position (a) : ON The pilot lamp (A) lights up actuated. : OFF The E.C.S.S. is not actuated.
Position (b) REMARK If the travel speed goes above 5 km/h (3.1 M PH), the ECSS is automatically activated; when the trave l speed g below 4 km /h (2.5 MPH), the ECSS is auto matically turned off. act with the stopper at the boom end, the ECSS effect is reduced. When the b ucket is fully tilted and is in cont act with the stopper at the boom end , the ECSS effect is reduced. Operate the bucket slightly to the DUMP po sition to move it away from the s topper at t he boom end. This ena the ECSS t o have effect. Please con tact your Komatsu distributor if yo u want to adjust the speed at which th e EC SS is actuated or turned