. OPERATION OPERATION CHECK WATER SEPARATOR, DRAIN WATER WARNING The water separator (1) forms one unit with the fuel pre-filter, and is at the bottom. 2. It is possible to judge the condition of water and sediment through transparent cap (3). If water or sediment is accumulated, set a container under drain hose (4) to collect the discharged water. 3. Loosen plug (2) and drain the water. 4. Tighten plug (2) as soon as fuel starts to be discharged from drain hose (4). (Tightening torque: 0.2 - 0.45 Nm {0.02 - 0.046 kgm}) water. 3 - 94 Each part of the engine is still h ighly heated immediately after the engine is stopped.
Do not attem pt to drain cooling water or remove the filter element cup. High pressure is generated ins ide the engine fuel piping, while the engin e is running. Wait for mor e than 30 seconds after the engine stop for the engine to su fficiently cool down. Then start with drain ing cooling water or rem oving the filter element cup. Do not bring fire close. 1. Open the engine side cov er on the right side of the machine 5. On this machine, sensor i s installed to detect if water is accumulated at the bottom of lamp on the machine monitor lights u p, carry out the above Steps 1 - 4 to drain the REMARK 5) of plug (2) with grease. der drain hose (4). drain all the sediment together with e (4).
mes out from drain hose (4), then ) with a suitable amount of grease. reful not to let the grease get on the n port (a) or the plug thread. and until it contacts the bottom. iner. 3) is dirty and the contents cannot be easily seen, clean transparent cap (3) when If plug (2) is stiff, coat O-ring ( 1) Set a fuel container un 2) Loosen plug (2), then the fuel from drain hos 3) Check that nothing co remove plug (2). 4) Coat O-ring portion (5 When doing this, be ca drain valve water drai 5) Screw in plug (2) by h 6) Remove the fuel conta If transparent cap ( replacing the filter. When washing, if pl the bottom.
ug (2) is removed, coat the O-ring wit h grease, then tighten by hand until it contacts