Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK ELECTRIC WIRING CAUTION TIRES 3 - 97 If fuses are frequently blown or if there ar e traces of short-circuiting on the electrical wiring, promptly ask your Komatsu e repair. sk your Komatsu distributor to locate the cause and make th Keep the top surface of the battery clean an d check the breather hole in the battery cap. If it is clogge d with dirt or du st, wash the battery cap to clear the breather hole. Check that the fuses are not damaged, th at the fuses are of the correct capacity, and that ther e are no signs of short circuits or disconnections in the electric wi ring. Check also that there are no loose terminals o r connectors. Tighten any loose parts.

ry, starting motor, and alternator. ammable material accumulated around the battery. Remove any such about the repairs and causes of problems. In particular, check the wiring of the batte Be also sure to check that there is no fl flammable material. Please consult your Komatsu distributor CHECK INFLATION PRESSURE OF TIRES pressure gauge, while the tires are cool, before starting work. d the rims. Check for loose wheel hub nuts (bolts). s according to the type of work. See Section "HANDLING THE Measure the inflation pressure with a tire pressure gauge, while the tires are cool, before sta rting Check for damage or wear to the tires an d the rims.

Check for loose wheel hub nuts (bolts) The appropriate inflation pressure differ (PAGE 3-142)" for details. CHECK CONDITION OF WINDOW WASHE R SPRAY hat the washer fluid is sprayed out properly. , clean the washer nozzle with a safety pin or thin wire. Operate the window washer and check t If the fluid does not spray out properly , clean the washer nozzle with a safety pin or thin If the condition is still not improved, pl ease ask your Komatsu distributor to carry out inspection and re CHECK WIPING EFFICIENCY OF WIPER Operate the wiper and check that it wipes the window properly under each operating speed: In termittent, low speed, high speed. he glass wet when checking.

Operate the window washer to make t If the wiping condition is poor, it is nec essary to clean the surface of the glass or replace th e rubber wipe r blade. If the condition is still not improved, pl ease ask your Komatsu distributor to carry out inspection and re pair. CHECK HORN he horn sounds. Operate the horn switch and check that t If there is any abnormality, please ask yo ur Komatsu distributor to carry out inspection and r epair. CHECK DEFROSTER FUNCTION Operate the air conditioner and check that the air blows out properly onto the front glass. If there is any abnormality, please ask your Komatsu distributor to carry out inspection an d repair.

Operate the rear heated wire glass sw itch and check that the rear glass surface is heate If there is any abnormality, please ask your Komatsu distributor to carry out inspection an d repair. CHECK LOCKS erly. cked, see "LOCKING (PAGE 3-141)".) Check that all places can be locked prop (For details of the locations that can be lo If any abnormality is found, please ask y our Komatsu distributor to carry out inspection and repair