. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WITH TRAILERS WARNING LOADING 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the brakes on the trailer securely and insert blocks (1) under the tires to hold the trailer in position. Set the distance (3) between ramps (2) to match the distance between the left and right tires, and make angle (4) of the ramps a maximum of 15 ° . If ramps (2) sag appreciably under the weight of the machine, put wooden block (5) under the ramps to support them. 3. Determine the direction of the ramp, then slowly load the machine. 4. Load the machine correctly in the specified position on the trailer.
3 - 144 TRANSPORTATI When transporting the ma chine, observe all related laws and regula tions, and be careful to as sure safety TRANSPORTATION P When transporting the m reference dimensions shown in "SPE CIFICATIONS (PAGE 5-2)".
Note that m achine specifications (weig ht and dimensions) vary depending on the kin When loading or unloading the machine, run the engine at low speed, tra vel at low speed, and operate When loading or unloading the machine, stop the trailer on firm level gro In addition, keep well away Use ramps of ample width, length, thickness, and strength, and install th em securely at an angle of les s than 15° When using an embankme nt, compact the fill soil thoroughly and make s ure that the slope face does not collapse. Remove the mud stuck to t he undercarriage to prevent the machine from slipping to the side on the ra In addition, remove any wa ter, snow, ice, grease, or oil from the ramps.
Never change direction on the ramps. There is danger that the machine If it is necessary to change direction, return to the ground surface or the tr ailer platform, correct the dire ction, and start a gain. The position of the center of gravity of the machine will change suddenly at the connection of the ram p and trailer, and there is danger of the machine lo sing its balance. Always drive slowly over thi s point. When loading or unloading , always use ramps or a platform. Proce