. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 152 BEFORE STORAGE e than one month), store as follows. When keeping in long-term storage (mor Clean and wash all parts, then store th e machine indoors. If the machine has to be stored outdoors, s elect level ground and cover the machine with a sheet. ents moisture from collecting. orage. ulic cylinder piston rod with grease. Completely fill the fuel tank. This prev Lubricate and change the oil before st Coat the exposed portion of the hydra Disconnect the negative terminals of th e battery and cover it or remove it from the machine and store it s eparately.
Set the work equipment lock lever to t he LOCK position to prevent the machine from moving. To prevent rust, fill with Komatsu genu ine supercoolant (AF-NAC) to give a density of at least 3 0% for t he engine coolant. If it is necessary to perform the rust-preventio n operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of o il will coat moving parts. At the same time, also charge the battery. wipe off all the grease from the hydraulic cylinder rods.
When operating the work equipment, wipe off all the grease from the hydraulic cylinder rods. If the machine is equipped with an air conditioner, operate the air conditioner for 3 to 5 minute s once a month to lubricateall parts of the air conditionerc check the refrigerant level twice a yea ompressor. Always run the engine at low idle when doin g this. I n addition, r. NOTICE If the machine has been stored without carry ing out the monthly rust-prevention operation, consult your Komatsu distributor before using it. When using the machine after long-term storage, do as follows before using it. cylinder rods. ints.
Wipe off the grease from the hydraulic Add oil and grease at all lubrication po When the machine is stored for a long p eriod, moisture in the air will mix with the oil. Check the o il befor e and after starting the engine. If there is water in the oil, change all the oil. ine pulley and no abnormality in the belt. ntact surface of the pulley, remove it with a wire brush. Check that there is no rust on the eng If there is excessive rust on the belt co ntact surface of the pulley, remove it with a wire brush.