. MAINTENANCE SERVICE PROCEDURE CHECK AXLE OIL LEVEL, ADD OIL WARNING operation. A: Front B: Rear REMARK Remove the mud and dirt from around plug (1), then remove the plug. cloth, wipe off any oil adhering to the oil level gauge attached to plug (1). 4 - 25 When checking the oil level, apply the parking brake and secure the front and rear frames with th After stopping the engine, the parts and oil are at a high temperature. W ait for the temperature to go down before starting the Perform this procedure if there is any sign of oil on the axle case. Inspect the machine on a horizon (If the r oad surface is at an angle, the oil level cannot be checked A: Fr 1. Sto p the engine and remove 2.
Wit 3. Set the oil level gauge (G) as shown in the right diagram. n the two lines (H) and (L) on the 4. (2): Axle Spot facing face) oil level should be betwee (3): The oil l evel gauge. If th e oil is below the (L) line, add axle oil through oil filler port (F). 5. If th e oil level is above the (H) line, drain the excess oil through drai n plug (P), then check the oil level again. l plug (1). m (9.5 to 12.5 kgm , 68.7 to 90.4 6. If th e oil level is correct, instal Tightening torque: 93 to 123 N lbft) Tightening torque: 93 to 123 N