Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN FINS WITH COMPRESSED AIR WARNING 2. Remove bolts (3) and open fan guard (2). NOTICE If the steam jet nozzle is brought too close to the radiator fins, it may Work under the following rough conditions. Jet pressure: Max 9.8 MPa (100 kg/cm 2 ) Nozzle diameter: Max diameter 2 mm Distance between nozzle and radiator fins: Min 100 mm Also, check hose clamps for looseness. 5. After cleaning, close fan guard (2) and install bolts (3). air. 4 - 30 Before opening the fan guard, sto p the engine, and hang a warning tag on the work equipment contr CLEANING WITH REAR GRILL OP 1. Open rear grill (1). 3.

Use compressed air to b low out any mud, dirt, or leaves It is also possible to use steam or ed air. clogging radiator fins (4). water in place of compress damage the fins, so keep the nozzl when cleaning. e a suitable distance away from the fins 4. Check the rubber hose. Re place with a new one if the hose is f ound to have cracks or t o be hardened by a ging CLEANING WITH ENGINE SIDE CO VER OPEN 1. Open the engine side cove machine. 2. Insert the steam jet noz radiator, oil cooler, afterc condenser (2), and carry o 3. Use an air jet nozzle to blo the mud and dirt that has d also to blow out to the front has accumulated on top of It is also possible to use ste 1.

Open the engine side cove rs on the left and right sides of the zle through the gap between the ooler (1) and the air conditioner ut cleaning. 3. Use an air jet nozzle to blo w out to the front of the machine all ropped down. Use an air jet nozzle of the machine the mud and dirt that the fuel tank. am or water in place of compressed