. MAINTENANCE SERVICE PROCEDURE BUCKET WITH TIP TOOTH WARNING and gloves. is horizontal. hatched portion (either left or right) and tap pin (2) out to the opposite side. 4 - 33 If the pin is hit out wit h strong force, there is d anger th at the pi n may fl y out. Chec k that there is no one in t he surrounding area There is danger of pi eces flying during the re placeme nt operation, so always wea r protective clothing, su ch as safety glasses Replace the teeth be fore they wear down as far a s the a dapter. 1. Raise the bucket to a suitable height, t hen put blocks (A) und the bucket to pre vent the bucket from coming down. Raise the bucket surface bucket 2.
Remove pin (2) i nstalled to the bucket , then r emove tooth (1 Put a rod (slightl y narrower than the pin) in contact 3. Fit new tooth (1) i n adapter (3), push in pin (2) p artially by han then knock it in w ith a hammer. 4. After operating th e machine for a few h ours, c heck th at the p does not come o ut. 5. If mounting bolts (4) or (5) of adapter ( 3) are l oose, ti ghten t hem. Tightening torque of mounting bolt m , 882.4 to 983.7 lbft) 0.3 to 672.7 lbft) (4): 1200 to 133 0 Nm (122 to 136 kg 4 to 98 3.7 lbft) (5): 814 to 912 N m (83 to 93 kgm , 60 0.3 to 6 72.7 lb