. MAINTENANCE SERVICE PROCEDURE LUBRICATING NOTICE (7) Steering cylinder pin (4 places) 4 - 52 When working on jo bsites where heavy-duty operations are frequent or when working continuously fo r more than eight hours shorten the lubricat ion interval and carry out lubrication more frequently. For the initial 50 ho urs, carry out lubrication every 10 hours. 1. Put the work e quipment horizontally in contact with the ground, then stop the 2. Using a grea in fittings marke d by the arrows. 3. After greasing , wipe off any old grease that was pushed out.
through the (1) Bucket pin (2 (2) Bucket link pin (3) Bell crank pin (1 place) pin (2 places) n (4 places) in (2 places) (4) Dump cylinder pin (2 places (5) Lift cylinder pi (6) Lift arm pivot p