Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING Prepare a filter wrench on remove it. 6. Take water separator cup (3) installed to the bottom of the 4 - 55 After the engine has been op erated, all parts are at high temperature, so do not replace the filter immediately. Wai t for al l parts to cool down before starting the operation. nside the engine fuel piping system when the engine is running. High pressure is generated i nside the engine fuel piping system whe When replacing the filter, w ait for at least 30 seconds after stopping the engine to let the int ernal pressure go down before replacing the filter. e close.

Do not bring any fire or flam NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has h ighly efficient filtering ab ility. When re placing th e filter cartridge, always use a genu ine Komatsu part. The common rail fuel injecti on system used on this machine consis ts of more precise parts t han the conventional inj ection pump and nozzle. If any part other than a genu ine Komatsu filter cartridge is used, dust or dirt may get in and cau se problems with the inj ection system. Always avoid using substitute parts. When carrying out inspectio n or maintenance of the fuel system, pay more attention than nor mal to the entr y of dirt.

If dirt is stuck to any part, use fuel to wash it off completely. 1. Open the engine side c over on the right side of the chassis. 2. The fuel pre-filter forms one unit with the water separator an d is located at the fron 3. Remove connector (1). After removing the con with a vinyl bag or tape t becoming dirty. o protect them and prevent them fro ch the fuel under the filter cartridge. 4. Set the container to cat 5. Using a filter wrench, tu rn filter cartridge (2) counterclockwis cartridge and turn it to t again. If it is damaged, he left to remove it. (This cup is use replace it with a new part.) 7.

Install cup (3) to the bot tom of the new fuel pre-filter cartridg When doing this, alway Tightening torque for cu When replacing the sea before installing it. 8. Check that drain plug ( s replace the seal ring with a new pa p: 10 Nm {1.0 kgm} l ring, coat the surface with clean fu pre-filter is tightened se Tightening torque: 0.2 - 9. Clean the filter holder.