. MAINTENANCE SERVICE PROCEDURE CHECKING FUNCTION OF ACCUMULATOR For details of handling the accumulator, see Section "HANDLING ACCUMULATOR AND GAS SPRING (PAGE 2-42)". 4 - 68 PPC ACCUMULATOR If the engine stops with the work e quipment raised, and it is impossible to start the engin e again, it is possible as an emergency measure to actuate the valve with the oil pressure stored in the accumulator and lower the work equipment to the ground. 1. Apply the parking brake. 2. Raise the work equipment to the maximum height, then operate the work equipment control lever to HOLD position (b). 3. Stop the engine. 4. Leave the work equipment lock lever in the FREE position. 5.
Check that the area around the machine is safe, then operate the work equipment control lever to FLOAT position (d) and lower the work equipment to a point 1m above the ground. 6. When the lift arm comes to the 1m position, return the work equipment control lever to LOWER position (c), and lower the work equipment slowly to the ground. REMARK Carry out the check within 2 minutes after stopping the engine. If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem. Carry out the check within 2 minu the machine is left with the en pressure will drop and it will be imp problem.
If the work equipment stops while it is moving, the gas pressure in the accumulator ha Please contact your Komatsu dis Replace the accumulator every 4 CHECK ALTERNATOR Contact your Komatsu distributor If the engine is started frequently , have this inspection carried out every CHECK ENGINE VALVE CLE ARANCE, ADJUST As special tool is required for rem oving and adjusting the parts, request your Komatsu distributor for service CHECK VIBRATION DAMPER peeling in the outside surface of the rubber. Check that there are no cracks or peeling in the outside surface of the If any cracks or peeling are found , contact your Komatsu distributor to have the parts r