Komatsu — OPERATION

. ATTACHMENTS, OPTIONS HANDLING FORK TOOL OPERATION LOADING OPERATION LOADING WARNING the 6 - 4 The operating speed of the f orklift is determined according to th e configuration o f the gro und, condition u nder foot, and size of the operating ar When operating the forklift, maintain the engine speed at near fu ll speed , and carr y out th e operation with t he speed range in 1st or 2nd. Use 3rd or 4th speed when The following explanation of the method of operating the forklift does no t cover all situatio ns.

The operatin g method differs according to each op When operating the forklift, use the safest and most efficient m When traveling with a load, do not turn suddenly or accelerate or d ecelerate suddenly. There is danger that the lo ad will fall off or the machine will tilt. The fork tilt angle differs acc ording to the load. If loads are stacked on top o f each othe r, and th e tilt angle is exces sive, there is danger that the top load w ill extend over the backrest of the carri age and slip to the 1. Adjust the distance betw een the forks to match the size of t load. To ensure the stability o the forks as large as po f the load, make the distance betwe ssible. 2.

Set the forks horizontal, drive forward slowly so that the load centered on the forks, a nd insert the forks under the load. 3. Insert the forks complet ely under the load and drive forw until the load is in conta ct with the backrest of the carriage. 4. Raise the forks so that they are several inches above t ground or the load under that the load rests again the forks, then tilt the forks and set st the backrest of the carriage.