13. TRANSPORTATION 13.5 REMOVING AND INSTALLING CAB If it is necessary to remove the cab for transportation, do as follows. A WARNING Always use lifting equipment of ample strength. REMOVING AND INSTALLING CAB If it is necessary to remove the cab when moving to a new job site, do as follows. REMOVING CAB Removing panels inside cab 1. Remove (pull out) left and right knobs @ of the car stereo, then loosen the nuts, and remove holder plate 0. 2. Remove 10 caps @ installed to the top surface of the panel. 3. Remove 18 panel mounting screws @ and washers 0, then remove panels @ and 8. Removing left and right door bottom plates 4. Remove mounting screws @ and washers @ (left and right:
6 places), then remove plates (II) (left and right: 2 places). Plate @ is the door seal protector plate. I AE210190 1 Removing blind caps for cab mounting bolts 5. Remove 7 blind caps @ installed at the front under the cab and under the left and right doors. After removing the cab, install blind caps @? again. 2-70