Komatsu — 21.2 TORQUE LIST

21.STANDARDTIGHTENlNGTORQUESFORBOLTSANDNUTS 21.2 TORQUE LIST Unless otherwise specified, tighten the metric bolts and nuts to the torque shown in the table. The tightening torque is determined by the width across the flats @ of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Nm (newton meter):

INm k 0.1 kgm & 0.74 Ibft Thread diameter of bolt (mm) (a) Width across flat (mm) (b) @ @ AD054300 b Nm kgm Ibft 6 10 13.2 + 1.4 1.35 + 0.15 , 3.73 + 1.03 8 13 31.4 + 2.9 3.2 r 0.3 23.2 k 2.1 L AD053380 10 17 65.7 + 6.8 12 19 112 -c 9.8 11.5 f 1.0 6.7 + 0.7 82.6 r 7.2 48.5 2 5.0 14 22 177 + 19 18.0 + 2.0 131 r 14 16 24 279 + 29 18 27 383 + 39 28.5 + 3 39 2 3 206 + 21 282 + 29 20 30 549 2 58 22 32 745 e 78 76 + 8 56 k 6 405 + 43 549 + 58 24 36 927 f 98 94.5 2 10 684 k 72 27 41 1320 r 140 135 k 15 973 r 100 30 46 1720 2 190 33 50 2210 + 240 225 2 25 175 2 20 1270 2 140 1630 2 180 36 55 2750 + 290 39 60 3280 e 340 280 + 30 335 + 35 2030 f 210 2420 + 250 NOTICE When tightening panels or other parts having tightening fix- tures made of plastic, be careful not to use excessive tightening torque:

doing so will damage the plastic parts. 3-13