1. Stop the engine and close valves @ of corrosion resistor (iJ. 2. Turn radiator cap @ slowly to remove it. 3. Set a container to catch the coolant under drain valve @ and drain plug 0. Open drain valve @ at the bottom of the radiator and drain plug @ on the side face of the oil cooler to drain the water. 4. After draining the water, close drain valve @ and drain plug 0, and fill with city water. 5. Open drain valve @ and drain plug 0, run the engine at low idling, and flush water through the system for 10 minutes. When doing this, adjust the speed of filling and draining the water so that the radiator is always full.
While flushing water through the system, watch carefully that the water inlet hose does not come out of the radiator water filler. 6. After flushing, stop the engine, open drain valve @ and drain plug 0, then close it again after all the water has drained out. 7. After draining the water, clean with a flushing agent. When washing, follow the instructions given with the detergent. L?i AE111450 8. After flushing, open drain valve @ and drain plug 0, completely drain all the water, then close the drain valve and drain plug, and fill with city water up to near the filler port. 9.
When the tank is filled to near the water filler port, open drain valve @ and drain plug 0, start the engine, run at low idling, and continue the flushing operation until clean water comes out. Adjust the amount of water flowing in and out to ensure that the radiator is always full during the flushing operation. I 10. When clean water comes out, stop the engine, and close drain valve @ and drain plug 0. 11. Replace corrosion resistor @ and open valves 0. For details on the corrosion resistor replacement method, see “24.6.7 REPLACE CORROSION RESISTOR CARTRIDGE”. 12. Add city water until the water overflows from the water filler port. 13.
To remove the air in the cooling water, run for five minutes at low idling, then for another five minutes at high idling. (When doing this, leave the radiator cap off.) 14. Stop the engine, wait for 3 minutes, and city water until the water level reaches near the water filler port, then tighten the cap. 3-22