24. SERVICE PROCEDURE 24.3.3 CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the engine side cover on the left side of the chassis. 2. Remove dipstick @ and wipe the oil off with a cloth. 3. Insert dipstick @ fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick 0. If the oil level is below the L mark, add engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 5. If the oil is above the H mark, drain the excess engine oil from drain plug 8, and check the oil level again. 6.
If the oil level is correct, tighten the oil filler cap securely and close the engine side cover. REMARK o When stopping the engine, check the oil level. l When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. l If the machine is at an angle, make it horizontal before checking. l While adding oil, take out the oil level gauge through the gauge guide to bleed the air from the crankcase. AD052340 24.3.4 CHECK OIL LEVEL IN STEERING CLUTCH CASE (INCL. TRANSMISSION CASE, TORQUE CONVERTER CASE), ADD OIL Remove dipstick @ and wipe the oil off with a cloth. 1. 2.
Insert dipstick 0 fully in the oil filler pipe, then take it out again. 3. The oil level should be between the H and L marks on dipstick 0. If the oil level is below the L mark, add engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 4. If the oil is above the H mark, drain the excess engine oil from the drain pulg, and theck the oil level again. 5. If the oil level is correct, tighten the oil filler cap securely and cloth the engine side cover. REMARK l When check the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking.
l If the machine is at an angle, make it horizontal before checking. l In case the work is carried out on sloped land of more than 20” declination, supply oil up to H level. 3-35