Komatsu — 24.6 EVERY 1000 HOURS SERVICE

24.6.7 REPLACE CORROSION RESISTOR CARTRIDGE I- a WARNING v If the engine has been operated, all parts will be at a high temperature, so never try to replace the cartridge immediately after stopping the engine. Always wait for the engine and other parts to cool down. l Container to catch drained coolant Prepare the following. l Filter wrench 1. Close levers @ (2 places). 2. Set a container under the cartridge to catch the drained coolant. 3. Using a filter wrench, remove cartridge 0. 4. Clean the filter holder, coat the thread and the seal surface of the new cartridge thinly with engine oil, then install the cartridge. 5.

When installing the cartridge, bring the packing surface into contact with the seal surface of the filter holder, then tighten a further approx. 2/3 turns. If the filter cartridge is tightened too far, the packing will be damaged and this will cause leakage of water; if it is not tightened enough, water will leak through the gap in the packing. To prevent these problems, always tighten to the specified tightening angle. 6. Open levers @ (2 places). 7. After replacing the cartridge, start the engine and check that there is no leakage of water from the filter seal surface. If any water leakage is found, check the tightening of the car- tridge. 3-56