24. SERVICE PROCEDURE 24.7.2 CLEAN ENGINE BREATHER ELEMENT 1. Wipe off all the dirt around the breather. 2. Remove breather 0. 3. Wash the whole breather in diesel oil or flushing oil, then blow it dry with compressed air. 4. Replace the breather O-ring with a new part, coat with engine oil, and install it. 24.7.3 CLEAN, CHECK TURBOCHARGER Contact your Komatsu distributor for cleaning or inspection. 24.7.4 CHECK PLAY OF TURBOCHARGER ROTOR Contact your Komatsu distributor to have the play checked. 24.7.5 CHECK ALTERNATOR, STARTING MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair.
If the engine is started frequently, carry out inspection every 1000 hours. 24.7.6 CHECK ENGINE VALVE CLEARANCE, ADJUST Contact your Komatsu distributor for inspection or adjustment. 24.7.7 CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of the rubber. If any cracks or peeling are found, contact your Komatsu dis- tributor to have the parts replaced. 3-58