Komatsu — 12.1 CHECK BEFORE STARTING ENGINE

12.1.2 CHECK BEFORE STARTING Always carry out the items in this section before starting the engine each day. CHECK COOLANT LEVEL, ADD WATER Do not open the radiator cap while cooling water is hot. Hot water may spout out. When removing cap, wait until the water temperature goes down and release radiator pressure little by little by loosening cap slowly, then remove the cap. I I g WARNING 1. Remove radiator cap (j) and check that coolant is above the bottom of the strainer as shown in the diagram. If necessary, add water through filler of radiator cap 0. 2. After adding water, start the engine, check the water level again after a five-minute idling, and add water if necessary. Radiator 3.

Tighten cap @ securely. NOTICE Do not rely only on the radiator water level monitor to check the coolant level. AE110590 CHECK FUEL LEVEL, ADD FUEL A WARNING When adding fuel, never let the fuel overflow. This may cause a fire. If you spill fuel, thoroughly clean up any spillage. Remove dipstick @ and wipe the oil off with a cloth. 1. 2. Insert dipstick @ fully in the oil filler pipe, then take it out again. 3. After completing work, fill the fuel tank through oil filler port @. For details of the fuel to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 4. After adding fuel, tighten the cap securely. Fuel capacity:

480 e (127 US gal, 106 UK gal) NOTlCE If breather hole @I on the cap is clogged, the pressure in the tank will drop and fuel will not flow. Clean the hole from time to time. ADO54210 2-38