SAFETY Welding, Grinding or Cutting Welding must always be done by a qualified welder and in a place equipped properly. The danger of fire and electrocution exists when welding. Never allow any unqualified personnel to do welding. When cutting, grinding or drilling it is advised to wear eye protection. Failure to do so may lead to an eye injury. Remark When welding on machine always remove battery cables before performing any welding procedures. Adjusting Track Tension Grease is pumped into the track tension adjustment system under high pressure.
If the specified procedure for maintenance is not followed when making adjustments, the grease drain plug (1) may fly out and cause serious injury or property damage. When loosening the grease drain plug (1) to loosen the track tension, never loosen it more than one turn. Loosen the grease drain plug slowly. Never put your face, hands, feet, or any other part of your body close to the grease drain plug (1). Do Not Disassemble Recoil Springs The recoil spring assembly is used to reduce the impact on the idler. It contains a spring under high pressure, if it is disassembled by mistake, the spring will fly out and cause serious injury or even death. Never disassemble the recoil spring.
When Using Hammer When using a hammer, pins may fly out or metal particles may be scattered. This may lead to serious injury. Always do as follows. If hard metal parts such as pins, bucket teeth, cutting edges, or bearings are hit with a hammer, there is a hazard that pieces might be scattered and cause injury. Always wear safety glasses and gloves. When hitting pins or bucket teeth, there is a hazard that broken pieces might be sent flying and injure people in the surrounding area. Always check that there is no one in the surrounding area. There is a hazard that the pin hit with strong force may fly out and injure people in the surrounding area. PC350LL-7E0 1-39