INTRODUCTION Breaking in a New Machine Your machine has been thoroughly adjusted and tested before shipment. However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the machine life. Be sure to break in the machine for the initial 100 hours, as indicated by the service meter. During breaking in: After starting, let the engine idle for five minutes to allow proper engine warm up prior to actual operation. Avoid operation with heavy loads or at high speeds. Avoid sudden starts or acceleration, unnecessarily abrupt stops and sharp steering except in cases of emergency.
The precautions given in this manual for operating, maintenance, and safety procedures are only those that apply when this product is used for the specified purpose. If the machine is used for a purpose that is not listed in this manual, KOMATSU cannot bear any responsibility for safety. All consideration of safety related items in such operations is the responsibility of the user. Operations that are prohibited in this manual must never be carried out under any circumstance. Plate Locations Product Identification Number (Pin) / Machine Serial No. Plate On the bottom right of the operator's cab 0-6 PC350LL-7E0