PERIODIC SERVICE 96 B Replacing Transmission Oil Filter [HST Type] 4. Put a film of clean transmission oil on the rubber seal of the new filter. 5. Quickly tighten the filter until it contacts the mounting surface, then, with a filter wrench, tighten it an additional 1 turn only. 6. After the new filter has been replaced, fill the transmission oil up to the upper notch on the dipstick. To avoid personal injury: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Remove the drain plugs at the bottom of the transmission case and drain the oil completely into the oil pan. 2.
After draining reinstall the drain plugs. (1) Gauge (2) Oil inlet (A) Oil level is acceptable within this range. 7. After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 8. Make sure that the transmission fluid doesn't leak past the seal on the filter. A To prevent serious damage to the hydraulic system, use only a KUBOTA genuine filter. (1) Drain plugs 3. Remove the oil filter. (1) Transmission oil filter [HST Type]