PERIODIC SERVICE 102 EVERY 2 YEARS B Flushing Cooling System and Changing Coolant To avoid personal injury: A Do not remove radiator cap while coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. 1. Stop the engine and let cool down. 2. To drain the coolant, open the radiator drain plug and remove radiator cap. The radiator cap must be removed to completely drain the coolant. 3. After all coolant is drained, close the drain plug. 4. Fill with clean soft water and cooling system cleaner. 5. Follow directions of the cleaner instruction. 6.
After flushing, fill with clean soft water and anti-freeze until the coolant level is just below the radiator cap. Install the radiator cap securely. 7. Fill with coolant up to the "FULL" mark on the recovery tank. 8. Start and operate the engine for few minutes. 9. Stop the engine and let cool. 10.Check coolant level of recovery tank and add coolant if necessary. (1) Radiator cap (2) Recovery tank (A) "FULL" (B) "LOW" A Do not start engine without coolant. A Use clean, fresh soft water and anti-freeze to fill the radiator and recovery tank. A When mixing the anti-freeze with water, the anti-freeze mixing ratio is 50 %. A Securely tighten radiator cap.
If the cap is loose or improperly fitted, water may leak out and the engine could overheat. A On cab type machines, coolant circulates through the heater. This means that one more liter or so of coolant is required. In changing coolant, pour coolant up to the filler port of the recovery tank. Turn ON the heater (shift the temperature control lever toward WARM), and run the engine for a while in order to warm coolant. Then stop the engine. When coolant has cooled down, some of the coolant in the recovery tank is sucked. Now the recovery tank is appropriately filled with coolant.
(1) Drain plug Coolant capacity L3240 6.0 L (6.3 U.S.qts.) L3540, L3940, L4240 7.5 L (7.9 U.S.qts.) L4740, L5040, L5240, L5740 8.2 L (8.7 U.S.qts.)