Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — Draining Clutch Housing Water

PERIODIC SERVICE 104 SERVICE AS REQUIRED B Draining Clutch Housing Water The tractor is equipped with split pin plug under the clutch housing. After operating in rain, snow or tractor has been washed, water may get into the clutch housing. Check it by pushing in the split pin. If water has entered into the clutch housing, remove the plug and drain the water, then install the plug again. B Bleeding Fuel System Air must be removed: 1. When the fuel filter or lines are removed. 2. When tank is completely empty. 3. After the tractor has not been used for a long period of time. C Bleeding procedure is as follows: 1. Fill the fuel tank with fuel, and open the fuel cock.

(1) Split pin plug (1) Fuel cock (2) Air vent cock (A) "CLOSE" (B) "OPEN" 2. Open the air vent cock on the fuel injection pump. 3. Start the engine and run for about 30 seconds, and then stop the engine. 4. Close the air vent cock. A Always close the air vent cock except for bleeding fuel lines. Otherwise, engine runs irregularly or stalls frequently.