Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — To Fold the ROPS

27 OPERATING THE TRACTOR OPERATING THE TRACTOR OPERATING NEW TRACTOR How a new tractor is handled and maintained determines the life of the tractor. A new tractor just off the factory production line has been, of course, tested, but the various parts are not accustomed to each other, so care should be taken to operate the tractor for the first 50 hours at a slower speed and avoid excessive work or operation until the various parts become "broken-in". The manner in which the tractor is handled during the "breaking-in" period greatly affects the life of your tractor.

Therefore, to obtain the maximum performance and the longest life of the tractor, it is very important to properly break-in your tractor. In handling a new tractor, the following precautions should be observed. OPERATING FOLDABLE ROPS (if equipped) To avoid personal injury: A When raising or folding the ROPS, apply parking brake, stop the engine and remove the key. Always perform function from a stable position at the rear of tractor. A Fold the ROPS down only when absolutely necessary and fold it up and lock it again as soon as possible. A Before proceeding to fold ROPS, check for any possible interference with installed implements and attachments.

If interference occurs, contact your KUBOTA Dealer. B Do not Operate the Tractor at Full Speed for the First 50 Hours A Do not start quickly nor apply the brakes suddenly. A In winter, operate the tractor after fully warming up the engine. A Do not run the engine at speeds faster than necessary. A On rough roads, slow down to suitable speeds. Do not operate the tractor at fast speed. The above precautions are not limited only to new tractors, but to all tractors. But it should be especially observed in the case of new tractors. B To Fold the ROPS 1. Remove both set bolts. B Changing Lubricating Oil for New Tractors The lubricating oil is especially important in the case of a new tractor.

The various parts are not "broken-in" and are not accustomed to each other; small metal grit may develop during the operation of the tractor; and this may wear out or damage the parts. Therefore, care should be taken to change the lubricating oil a little earlier than would ordinarily be required. For further details of change interval hours. (See "MAINTENANCE" section.) (1) Set bolt