John Deere 2120 Tractor — tm4252

30 Fuel System 20-6 ROOSA MASTER Fuel Injection Nozzles Model 2120 Tractor TM=4252 (Dec-70) Place the injection nozzle in a vise, using holding fixture No. 16475 which is supplied with the special injection nozzle tool kit. Loosen lock nut 13 on the adjusting screws (see fig. 1). Unscrew and remove spring pressure adjusting screw 14 and lift adjusting screw 12 from nozzle body 4. Unclamp nozzle and remove clamp 15. Invert nozzle and catch in your cupped hand the parts which will now fall out: ball washer 11, upper spring seat 10, pressure spring 9 and lower spring seat 10. If nozzle needle 3 also slips out, hold it carefully by its stem (see fig.

8) and not by the end with the nozzle needle seat. Do not bend needle. Fig. 9 Removal of Nozzle Needle Using Special Tool No. 16481 If the nozzle needle does not slide freely from the nozzle body when the injection nozzle has been turned over, use special tool No. 16481 as shown in fig. 9. Should the needle no longer be in its deepest position in the nozzle body, first push it completely into the nozzle body with the aid of the special tool (clamp holder) to avoid bending the needle when the tool is applied.

Turn the nut clockwise, slide the tool as far as possible onto the needle so that the gripping device gets a hold of it, then turn the knurled nut to the left to secure the nozzle needle. Remove the needle from the nozzle body by carefully pulling the tool. Fig. 8 Correct Handling of Nozzle Needle IMPORTANT: If several injection nozzles are disassembled at the same time, make sure that the nozzle needles and nozzle bodies are not mixed up. When assembling, the nozzle needle must be in¬ stalled into the same nozzle body from which it was taken. Completely unscrew stroke adjusting screw 12 from spring pressure adjusting screw 14 with small screw driver No.

16504 which is provided with the special nozzle tool kit. REPAIR CLEANING INJECTION NOZZLE PARTS Injection Nozzle Body Carefully remove all carbon deposits from the nozzle tip and the groove for the lower sealing ring with solvent or clean Diesel fuel and brass wire brush No. 16488 which is supplied with the special nozzle tool kit. Never use a steel wire brush for this purpose. Printed in Germany