John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Power Train 50 HIGH-LOW Shift Unit 10-7 DISASSEMBLY CAUTION: Make sure special tool is centered over spring washer pack. After snap ring is removed, release pressure slowly and keep fingers away. Remove cover from HIGH-LOW housing and pull HIGH-LOW shift assembly out of housing, taking care of the thrust washer located between housing and clutch drum. Remove spring washers and annular piston. Remove three short cap screws (see 26, fig. 7) and three long cap screws 25 from cover plate 27. Remove cover plate as well as planet pinion carrier. The planet pinions rotate in a carrier on shafts (see 45, fig.

7) and are supported by two sets of needle bearings 42 which are separated by spacer 44. Prior to removal, rotate planet pinions until "V" marks match the "V" marks on sun gear. Then identify planet pinions and sun gear so that marks on pinions exactly match the SAME marks on sun gear when reassembling. Store disks in installation sequence. NOTE: Identification is necessary only if old planet pinions are to be installed again. To remove planet pinions, pull bearing pins slightly out of planet pinion carrier by means of a 1/4 in. cap screw and remove detent ball at end of each bearing pin. Be careful not to lose the balls.

Pull bearing pins completely out of carrier and remove planet pinions, needle bearings, spacers and thrust washers. NOTE: Be careful not to lose the needle bearings. There are 44 needles in each planet pinion or a total of 132 needles for the pinion set. Fig. 6 Removing Annular Piston of HIGH Disk Clutch a Special tool No. 19.58-90,617 1 Annular piston 2 Snap ring 3 Spring washers Remove sun gear and thrust washer from planet pinion carrier. To facilitate removal of annular piston (see 1, fig. 6) from planet pinion carrier or HIGH clutch drum, first remove snap ring 2 retaining spring washers 3 in planet pinion carrier or clutch drum. Position special tool No.

19.58-90.617 (see item "a", fig. 6) on spring washers and press washers down so that the snap ring can be removed. Printed in Germany