John Deere 2120 Tractor — tm4252

50 Power Train 10-10 HIGH-LOW Shift Unit Model 2120 Tractor TM-4252 (Dec-70) Check spring washers 32 for damage or flattening: place each washer on a flat support with cupped side down and measure height of washer (see Speci¬ fications). Inspect oil manifold 9 and its bushing for damage. Replace complete oil manifold, if necessary. Check HIGH-LOW housing and hollow drive shaft 54 (forming an integral unit) for damage. Check oil seal ring 52 and bushing 51 for serviceability. Press in new oil seal ring with numbered side facing driver. Check disks 28 and separator plates 29 for wear. Make sure grooved pattern of disk facings is not worn or rubbed off. Otherwise replace disk.

Check disk splines for broken teeth. For thickness of an individual disk as well as total stacked height of a new disk pack see Specifications. If necessary, remove unserviceable bushing 51 from HIGH-LOW housing. Press in new bushing by means of driver No. 19.58-90.613 and drift No. 815 until drift is flush against HIGH-LOW housing. Check planet pinion carrier 26 for cracks or other damage and replace, if necessary. Inspect brake hub 30, gear and hub of drive shaft 47, sun gear 40 and planet pinions 43 for chipped or worn teeth. Replace parts, if necessary. CLUTCH HOUSING Check oil seal ring (see 57, fig. 7) and bushing 56 of clutch housing for serviceability.

Press new oil seal ring in clutch housing bore so that its sealing lip faces driving tool and ring is within clutch housing face by a specified dimension (see Specifi¬ cations). NOTE: If one or two planet pinions must be replaced, install a complete set (3) of pinions as they are matched and are available only as a com¬ plete set. Check bearing needles 42 supporting planet pinions for worn spots. A total of 132 bearing needles are used. Remove unserviceable bushing 56 and install new bushing by means of driving tool No. 19.58-90.273 in clutch housing so that lube oil bores of bushing match housing bores. Coat bore of bushing with a film of oil.

Check transmission input shaft 2 for wear and damage and replace, if necessary. Replace sealing rings 1,4 and 6 on input shaft. When replacing sealing ring 4, first remove retaining ring 5 from input shaft. Now, if necessary, pull oil tube 3 out of input shaft. Press new oil tube in retaining ring 5. Slide sealing ring 4 on retaining ring and push oil tube with retaining ring and sealing ring in transmission input shaft. Examine drive shaft 47 for wear or damage. If bushing 46 is damaged, remove it from shaft and press in new bushing with open ends of oil grooves facing outward. Replace sealing rings 1 on drive shaft. Fig.

9 Installing Hydraulic Pump Pressure Line Adapter 1 Adapter 3 Washer 2 Cap screw Printed in Germany