Model 2120 Tractor TM-4252 (Dec-70) Power Train 50 Differential 20-3 Remove bevel gears 3 (fig. 3) and bevel pinion shafts 1 with bevel pinions 2 from the differential housing. NOTE: To obtain accurate preload adjustment, differential end play must not exceed specified dimension (see Specifications). Examine the thrust and bearing surfaces of both bevel gears. If the bevel gears are worn or damaged, the bores in the differential housing and cover may also be damaged. Record end play shown on the dial indicator and add a specified value (see Specifications) to the recorded end play. Then remove enough shims from the shim pack on the right bearing housing to equal the calculated measurement.
Install the remaining shims to obtain the correct bearing preload. Check bevel pinions and bevel pinion shafts for excessive wear. If these parts are damaged or excessively worn, also replace parts they are in mesh with, or they are sliding on. ADJUSTING BACKLASH OF DIFFERENTIAL Check ring gear for wear or damage. If the ring gear is no longer serviceable, separate from differential housing by removing rivets and replace. After adjusting the preload, mount the dial indicator as shown in fig. 4 and check the backlash between the differential drive shaft pinion and the ring gear at several points. IMPORTANT! If the ring gear is replaced, also replace the differential drive shaft.
These parts are furnished as matched sets and are not available individually for replacement. The number of teeth of the differential drive shaft pinion and of the ring gear can be determined from without. These figures are stamped into the trans¬ mission case, to the left of the rockshaft housing. Check taper roller bearings if still serviceable. NOTE: On tractors equipped with hand-brake, push the brake hub and disk 6 on the splines of the bearing cover, before pressing the roller bearing cone on the differential housing cover 8 (fig. 1 ). Coat bevel gears, bevel pinions and bevel pinion shafts with transmission oil, before installing them.
Install differential housing cover on differential housing and tighten screws to specified torque. Fig. 4 Measuring Backlash Adjust backlash by transferring differential bearing housing shims from one side of the case to the other. ADJUSTMENT CAUTION! The total thickness of the shims must be maintained so that the correct preload of the roller bearings is not altered. PRELOAD ADJUSTMENT OF DIFFERENTIAL BEARINGS Install both bearing housings. Place a number of shims 3 behind the right-hand housing 14 (fig. 1). Check the end play of the differential assembly with a dial indicator. If necessary, add more shims under right-hand bearing housing until measurable end play is obtained.
To increase backlash, move shims from left to right. To decrease backlash, move shims from right to left. See Specifications for correct backlash measurement. Printed in Germany