John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Front Axle, Steering System and Brakes 60 Brakes 15-7 REMOVAL ADJUSTMENT Drain transmission oil and remove rockshaft (see section 10, group 25). After having installed all hand brake parts, tighten brake band adjusting screw 22 (fig. 7) until brake band fully contacts brake disk. Then back off screw by one turn. Remove hand brake parts as shown in fig. 7. Before removing brake disk 31, remove differential unit (see section 50, group 20). REPAIR Check all hand brake parts for serviceability and repair or replace, if necessary. BRAKE FACINGS If facings are loose or so much worn that grooves on sides of facings are no longer visible, replace facings.

When fitting a new facing, insert rivets from inside and peen on the outside. BRAKE DISK Check brake faces and carefully smoothen rough spots. Replace brake disk, if badly worn or scored. L 50244 Fig. 8 Adjusting Hand Brake TENSION SPRING Tension spring 23 (fig. 7) should have a specified resilience at a given spring length (see Specifi¬ cations). Tighten brake band support screw 32 (fig. 7) at bottom of transmission case finger-tight. Then back off 2 turns and secure by means of hex. nut 34. INSTALLATION Install the components, reversing the sequence observed for removal (as shown in fig. 7). NOTE: Hook in tension spring 23 with the brake band still removed. Printed in Germany