John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Hydraulic System 70 Hydraulic Pump and Transmission Oil Pump 15-7 Secure pump drive shaft 1 to crankshaft pulley, using coupler halves 6, two cap screws 7 and self locking hex. nuts 5. Tighten two coupler screws 7 only after hydraulic pump has been installed (the two coupler halves should rest loosely on the special screws 2). Installing Hydraulic Pump Place Woodruff key in pump shaft groove and insert pump shaft in drive shaft assembly. Fasten pump to front support and tighten four cap screws to recommended torque. With pump secured to front support, arrange pump drive coupler halves so that they only contact the rubber bushes, but not the special screws.

u Tighten two cap screws 7 (fig. 6) of coupler halves 6 alternately to specified torque then re-tighten alternately to specified torque. Tighten two lock nuts 5 to the specified torque. Then tighten cap screw 4 of pump drive shaft 1 to specified torque. Fig. 7 Stroke Control Valve Adjusting Screw 1 Adjusting screw 2 Hydraulic pump Connect oil lines to hydraulic pump. Back off stroke control valve adjusting screw 1 (fig. 7) until spring pressure on screw is completely relieved. Then turn adjusting screw in until pressure gauge shows specified stand-by pressure (see specifications). Hold adjusting screw and tighten lock nut. ADJUSTMENT Install a high pressure gauge as explained in group 5.

Set all hydraulic controls in neutral and place the transmission range shift lever in park or neutral position. Apply the handbrake. Start the engine and run at the rated speed. Run engine for approx. 5 - 10 minutes, then recheck adjustment. Printed in Germany